The skySensor EXP is the ADS-B in companion to the skyBeacon ADS-B out solution. This experimental-only wingtip ADS-B in receiver provides an easy to install path for dual band ADS-B in. The skySensor replaces your existing aircraft position light and uses the existing mounting location, breaker, and wiring while integrating an LED Navigation and Anti-Collision strobe light. The Wi Fi signal generated allows you to view 978 MHz and 1090 MHz traffic within your existing mobile flight software.
Done as a minor alteration with IA, works very well and so much better then the old dull bulb with no strobe.
Matt
20.11.2019
This CAN be installed on a certified aircraft if done as a minor alteration. Logbook entry and IA signoff. Works great.
William S
17.03.2019
Great concept! Didnâ??t want the fuss of a portable battery powered unit. The problem is is have droop wingtips and the Skysensor antenna doesnâ??t allow a fit (not even with their adaptor).
Robert
27.01.2020
Didnâ??t fit the tip perfectly on the pa-28 but install otherwise went without a hitch.
W. L
19.04.2020
Seems like a great product for use with most portable GPS units, iPads or Android devices using WiFi ADS-B IN data information. My question is, would the WiFi signal to the cockpit be substantially hampered when installed on a low wing aircraft with aluminum wings because the units antenna is facing downward with the wing potentially blocking the signal to the cockpit, where high wing aircraft have a more line-of-sight WiFi signal to the cockpit? In any case, the skySensor does seem like a nice match to the UAvionix sky Beacon.
Ответ:The Skysensor transmits weather and traffic to the following APPS: Foreflight WingX FltPlan Go iFly GPS Avare Naviator AvPlan Aerovie EasyVFR Skydemon FlyQ
Ответ:The intended design and installation is outside of the wingtip replacing the light. Any other installation would be at the discretion of the builder and operator as this is an experimental aircraft unit.
Ответ:The skybeacon is an ADS-B OUT solution, therefore does not require to be interfaced to foreflight. The skysensor is an ADS-B IN unit that does interface to foreflight among other apps.